Integrated systems testing: energy sources and direct controls

Integrated testing runs multiple building systems together, so equipment can start, move or change state without local warning.

High-energy check

Treat the whole test boundary as high energy. Automatic starts and state changes are the defining exposure.

This task's main energy sources are not calculated by this tool. Use the trigger checks below and competent-person verification.

Trigger checks

Electrical
Current, voltage, energisation, arc flash or stored electrical energy.
Mechanical
Moving parts, tools, tension, rotation or stored mechanical force.
Pressure
Compressed gas, liquid, hydraulic, pneumatic or vacuum energy.
Thermal
Heat, cold, flame, steam, sparks or thermal stress.

Direct controls to verify

Ticks stay on this screen only. Nothing is saved or sent.

Test boundary and automatic-start areas are identified and marked.
Work inside the test boundary is controlled by permit during the test.
Equipment that can start automatically is signed at the equipment.
A single test authority controls starts, stops and changes.
All trades in the boundary are briefed before the test window.
Stop if unplanned operation occurs.

For your SPA or pre-start

State the systems in the test, the areas where automatic operation is possible, how those areas are marked and how work in them is controlled.

Limitations: This tool supports planning and verification only. It does not replace competent risk assessment, legal duties, employer procedures, client requirements or competent supervision.